ProForm 495Pi PFTL33105.0 User Manual

Page 8

6. Hold the Console Base (26) near the right Handrail (18).

Attach the end of the ground wire on the Console Base
to the indicated small hole in the Handrail with a Silver
Ground Screw (27).

Connect the Wire Harness (28) to wire harness on the
Console Base (26).

Make sure to connect the connec-

tors properly (see the inset drawing). The connectors
should slide together easily and snap into place. If
the connectors do not slide together easily and snap into
place, turn one connector and try again.

IF THE CON-

NECTORS ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.

Ground

Wire

7. Set the console assembly on the Handrails (18); insert

the excess wiring down into the right Handrail. Attach the
console assembly with four 3/4” Screws (2) and two
Console Bolts (22) with two 1/4” Star Washers (21).
Make sure that no wires are pinched. Start all four
Screws and both Console Bolts before tightening
any of them.

5. Hold one of the Handrails (18) near the Right Upright

(36). Insert the Wire Harness (28) into the hole in the
bottom of the Handrail and out of the hole in the top as
shown. Remove the tie from the Wire Harness.

Set the Handrail (18) on the Right Upright (36), and
tighten two Handrail Bolts (20) with two Handrail Star
Washers (19) into the Handrail and the Right Upright.
Make sure that the Wire Harness (28) does not get
pinched.

Attach the other Handrail (18) to the Left Upright (31) as
described above. Note: There is not a wire on the left
side.

Console Assembly