ProForm 495Pi PFTL33105.0 - Manual (Page 10)

10
11. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the
walking belt (see page 17). To protect the floor or carpet, place a mat under the treadmill.
10 Attach the Latch Housing (30) to the Left Upright (31) with
two 3/4” Screws (2). Make sure that the large hole in
the Latch Housing is on the side shown. Do not over-
tighten the Screws.
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin as shown. Insert the pin into
the Latch Housing (30), and tighten the knob back onto
the pin.
2
30
31
10
Knob
Pin
Collar
Spring