Pioneer DVH-P5900MP - Manual (Page 51)

Initial Settings
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press FUNCTION and hold until function
name appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press
FUNCTION to select one of the initial
settings.
CLOCK AJST (clock)
—OFFCLK (off clock)—
FM STP (FM tuning step)
—AUTOPI (auto PI
seek)
—WARN (warning tone)—AUX1 (auxili-
ary input1)
—AUX2 (auxiliary input2)—V.IN
(AV input setting)
—CAMRA (rear view camera
setting)
—R-SP (rear output and subwoofer
controller)
—E-SCRL (ever scroll)—TV (TV sig-
nal setting)
—D.ATT (digital attenuation)—
A.RESET (audio reset)
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down
FUNCTION until the unit turns off.
# When you select CAMRA in V.IN, you can se-
lect
CAMRA.
# When the multi-channel processor (e.g., DEQ-
P6600) is connected to this unit, you can operate
D.ATT and A.RESET instead of R-SP.
Setting the clock
Use these instructions to set the clock.
1 Press FUNCTION to select CLOCK AJST.
2 Press c or d to select the segment you
wish to set.
Hour
—Minute
As you select segments of the clock display
the segment selected will blink.
3 Press a or b to set the clock.
Pressing a will increase the value of the se-
lected segment. Pressing b will decrease the
value of the selected segment.
Turning the off clock display on
or off
If the off clock display is turned on, when the
sources are off, the clock appears on the dis-
play.
1 Press FUNCTION to select OFFCLK.
2 Press a or b to turn OFFCLK on or off.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
1 Press FUNCTION to select FM STP.
2 Press c or d to select the FM tuning
step.
Pressing c or d will switch the FM tuning
step between 50 kHz and 100 kHz while AF or
TA is on. The selected FM tuning step will ap-
pear in the display.
Note
The tuning step remains at 50 kHz during manual
tuning.
Operating this unit
En
51
Section
03
Operating
this
unit