Pioneer DVH-P5900MP - Manual (Page 44)

+6 to
–6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.
5 Press BAND to cancel the 7-band gra-
phic equalizer adjustment.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press AUDIO to select LOUD.
2 Press a to turn loudness on.
Loudness level (e.g., LOUD MID) appears in
the display.
# To turn loudness off, press b.
3 Press c or d to select a desired level.
LOW (low) —MID (mid)—HIGH (high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
1 Press AUDIO to select SUB.W.
# You can also select the subwoofer setting
menu by pressing
SW on the unit.
2 Press a to turn subwoofer output on.
SUB.W NOR appears in the display. Subwoo-
fer output is now on.
# If the subwoofer output phase has been set to
the reverse,
SUB.W REV will be displayed.
# To turn subwoofer output off, press b.
3 Press c or d to select the phase of sub-
woofer output.
Press c to select reverse phase and REV ap-
pears in the display. Press d to select normal
phase and
NOR appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Press SW to select 80HZ 0.
# You can also select the subwoofer setting
menu by pressing
AUDIO on the unit.
# When the subwoofer output is on, you can se-
lect
80HZ 0 (subwoofer setting).
2 Press c or d to select cut-off frequency.
50Hz
—63Hz—80Hz—100Hz—125Hz
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Press a or b to adjust the output level
of the subwoofer.
+6 to
–24 is displayed as the level is increased
or decreased.
Boosting the bass
Bass boost function boosts the bass level of
sound lower than 100 Hz. The more the bass
level is increased, the more the bass sound is
emphasized and the entire sound becomes
powerful. When using this function with the
subwoofer, the sound under the cut-off fre-
quency is boosted.
1 Press AUDIO to select BASS.
# You can also select the bass boost setting by
pressing and holding
SW.
2 Press a or b to select a desired level.
0 to +6 is displayed as the level is increased or
decreased.
Operating this unit
En
44
Section
03