Paladin Tools LAF2301 - Manual (Page 6)

4
SAFETY INSTRUCTIONS
WORK SAFELY - A CAREFUL OPERATOR IS THE BEST INSURANCE AGAINST ACCIDENTS !!
WARNING SECTION [CONTINUED]
WARNING
Obey all the safety instructions
listed in this section and throughout
this manual. Failure to obey
instructions in this section could
result in death or serious injury.
WHEN DEALING WITH HYDRAULICS DURING ANY
TYPE OF ASSEMBLY, OPERATION, MAINTENANCE,
OR OTHER WORK ON OR NEAR THIS PRODUCT:
x
Hydraulic fluid under pressure can penetrate the
skin and cause serious injury or death. Hydraulic
leaks under pressure may not be visible!
x If any fluid penetrates the skin, GET IMMEDIATE
MEDICAL ATTENTION!!
x Wear safety glasses, protective clothing, and use a
sound piece of cardboard or wood when searching
for hydraulic leaks. DO NOT USE YOUR HANDS!
x Before connecting or disconnecting hydraulic hoses,
read your tractor or power unit’s operator’s manual
for detailed instructions on connecting and
disconnecting hydraulic attachments.
x Make certain that all parts meet the specifications for
this product when installing or replacing hydraulic
hoses or fittings.
x After connecting hydraulic lines:
¾ Slowly and carefully raise the loader and cycle
the rollback / dump cylinders to check hose
clearances and to check for any interference.
¾ Operate the hydraulics on this product to check
hose clearances and to check for any
interference.
¾ Make certain that the hoses cannot interfere with
or actuate the quick-attach mechanism.
¾ Make certain that hoses will not be pinched, or
get tangled, in any equipment.
x Do not lock the auxiliary hydraulics of your power
unit in the “ON” position.
x Refer to your power unit’s operator’s manual and
this manual for procedures and intervals, then
inspect and maintain the entire hydraulic system to
insure that the fluid remains clean, that all devices
function properly, and that there are no fluid leaks.
WHEN MOUNTING THIS PRODUCT TO YOUR
POWER UNIT:
x Refer to the operator’s manuals of your power unit,
your loader, and your quick-attach for special or
detailed mounting instructions.
x This product should fit onto the quick-attach or
loader arms of your power unit the same as the
original products that were designed by your loader /
quick-attach manufacturer.
x If this product does not fit properly, contact FFC
before operating.
x Never place your finger into the mounting plate or 3-
point hitch or loader holes. A slight movement of the
power unit or this product could cause serious injury.
BEFORE EACH USE, THOROUGHLY INSPECT THIS
PRODUCT AND:
x
Make certain that all safety signs are in place and
legible. Refer to the safety sign page in this manual
for the placement of safety signs for this product.
x Replace all damaged or excessively worn parts and
hardware only with genuine FFC parts or with
properly rated fasteners, hydraulic hoses, or fittings.
x Make certain that all locking pins, latches, and
connection devices are properly installed and
secured.
x Make certain that all protective guards, canopies,
doors, etc., are in place and secure.
WHEN OPERATING THIS PRODUCT IN
ACCORDANCE WITH DESIGN INTENTIONS:
x Contact utility companies before digging. Know your
digging area! Avoid hitting underground cables and
pipes, overhead wires, and other hazards.
x Do not drive near the trench. Always back away from
the trench before turning.
x Never use backhoe on a power unit that is not
equipped with a cab or ROPS, and operator
restraints (seat belts or equivalent devices).
x Do not use the backhoe to dislodge overhead
objects. Objects could fall and cause injury.
x Do not attach a jack hammer to the backhoe.
x Be careful when raising loaded bucket. Objects
could fall from bucket toward bystanders or operator.
x Know your loader’s safe operating weight limit, and
the weight of loaded attachment.
x Never dig close to loader’s wheels or under the
loader; this can cause a cave in and vehicle
overturn.
x Do not drive near the trench. Always back away from
trench before turning.
x Always dump loaded bucket on uphill side of
backhoe to minimize possibility of upset.
x Use caution when working close to fences and
ditches, or on uneven ground.
WHEN ADJUSTING, SERVICING OR REPAIRING THIS
PRODUCT:
x
Make no modifications to your Backhoe.
x When making repairs, use only genuine FFC parts
or, for fasteners, hydraulic hoses, or hydraulic
fittings, use only properly rated parts.
x Replacement parts, for parts with safety signs
attached, must also have safety signs attached.