Philips VCR 462 - Manual (Page 5)

Before Using Your VCR 5
Putting Batteries in the Remote Control
Using the Remote Control
3
Replace the battery compartment lid.
2
To record again, cover the hole with cellophane tape.
• Point the remote control at the VCR’s remote sensor.
• Do not put objects between the remote control and the VCR.
• Press the VCR button before pressing other VCR operation but-
tons.
• Press the TV button before pressing other TV operation but-
tons.
• Press the CBL/DSS button before pressing other Cable Box or
DSS Receiver operation buttons.
• The remote control and its batteries
are supplied.
• Do not mix alkaline and manganese
batteries.
• Do not mix old and new batteries.
Helpful Hints
VCR Maintenance
• In this VCR, use only tapes with the mark.
• Make sure any light adhesive stick-on notes are removed from
the video cassette tape before putting the tape in the VCR.
Removable labels like these can jam the VCR.
• Periodic maintenance is required to maintain your VCR’s perfor-
mance. Your VCR has an automatic head cleaner, but the video
heads eventually will require cleaning or replacement. Cleaning or
replacement of the video heads should be performed only by an
authorized service center.
Erase Protection
Video cassette tapes have record tabs to ensure that recordings
are not accidentally erased.
1
To prevent accidental erasure, break off the tab with a
screwdriver.
1
To remove the battery compartment lid, push in the tab,
then pull up the lid.
2
Place three AA batteries inside the battery compartment
with their polarities (+ and – ends) aligned as indicated.
1
2
1
2
3