Pioneer VSX-59TXi - Manual (Page 79)

Using other functions 09
79
En
Resetting the system
Use this feature to reset the system to its factory default
settings (see Default receiver settings below).
1 Switch the receiver into standby.
2 While holding down the front panel DIGITAL NR
button, press and hold STANDBY/ON for about
three seconds.
The display shows
RESET?.
3 Press the front panel OPTION + button.
The display shows OK?.
4 Within 5 seconds, press OPTION –.
The receiver should now be reset.
Note
• This doesn’t affect the presets that you have
programmed into the remote control (see Using the
remote control with other components on page 67).
See Resetting the remote control below to do this.
Default receiver settings
The table below shows the factory default settings. When
you reset the system, the receiver reverts to these
defaults:
Setting type Default setting Page ref.
Input DVD/LD
Master volume – – – dB (no sound)
Listening mode STANDARD (video inputs,
multichannel inputs, USB)
STEREO (audio inputs) page 43
Advanced surround
effect level 90 (5/7CH STEREO)
50 (all other modes) page 45
Listening mode (w/
headphones) STEREO page 46
USB / multichannel
input channel setting 8 channels page 47
Stream Direct mode SD:1 NORMAL (ON) page 47
Acoustic Calibration
EQ OFF (switches to ALL CH ADJ
after the Auto Surround Setup) page 48
Input signal select AUTO except multichannel
inputs (
ANALOG) and USB
( DIGITAL)
page 48
Surround Back
Channel mode ON (with surround back
speaker(s) connected) page 50
Virtual Surround Back
mode OFF page 51
Hi-bit/Hi-sampling OFF page 52
Midnight/Loudness OFF page 52
Tone BYPASS page 52
Digital NR OFF page 53
Dual mono CH1 page 53
Speakers Systems Normal Surround page 58
Speaker B setting Second Zone page 58
Speakers (front,
center, surround,
surround back) setting All SMALL page 59
Subwoofer setting YES page 59
Crossover frequency 80Hz page 59
Channel levels All 0 dB (no adjustment) page 60
Speaker distance
settings All 10 ft. page 61
Acoustic Calibration 0dB (no calibration) page 61
X-Curve OFF (switches to ON after the
Auto Surround Setup) page 61
Tape 2 monitor OFF page 75
Input attenuator OFF (all inputs) page 76
Sound delay 0.0 frames page 76
SACD gain 0dB page 77
Speaker A/B setting A page 80
Digital jack
assignment Digital-1 (coaxial) – DVD/LD
Digital-2 (coaxial) – TV/DVD
Digital-3 (coaxial) – CD
Digital-4 (optical) – SAT
Digital-5 (optical) – DVR/VCR1
Digital-6 (optical) –
CD-R/TAPE1/MD
2
RF (coaxial) – DVD/LD
page 90
Component video jack
assignment Component1 – DVD/LD
Component2 – OFF
Component3 – OFF page 91
Video input
assignment MULTI IN – OFF
USB – OFF page 92
Bass Peak Level OFF (No limit) page 93
Dynamic range
control OFF page 94
OSD overlay ON page 94
12 volt trigger OFF · OFF page 95
THX Ultra2 subwoofer NO page 96
Surround back
speaker position 0–1ft page 96
Setting type Default setting Page ref.