Polycom KIRK ISDN - Manual (Page 2)

14129500-HD, Ed.003, Page 2
Introduction
The KIRK ISDN Interface Card creates the interface between the switch and the digital cordless lines
in the DECT solution. Furthermore, the KIRK ISDN Interface Card secures a galvanic isolation
between the DECT solution and the switch (or the network provider).
1. KIRK ISDN NET5 Interface Card Features
The KIRK ISDN NET5 Interface Card contains the following features:
• The 2 Mbps KIRK ISDN Interface Card performs a 32 channel digital interface
• Up to 30 simultaneous conversations
• One RJ45 for 2 Mbit connection to Ethernet
• External data/paging and setup via RS232 serial interface
• Local RS232 for configuration, maintenance and debugging
• Transparency for the ISDN CLIP function
• Display (call info)
Additional KIRK ISDN QSIG 3.0 Interface Card features are:
• Call Hold
• Call Waiting
• Call Transfer
3. Installation
1 Power down the KIRK Wireless Server.
2
Remove the top cover by unscrewing the screws on both sides of the KIRK Wireless Server and the
screws at the rear panel.
KIRK ISDN Interface Card
3
Remove the blind cover plate in front of the slot closest to the power supply (see figure above).
4
Insert the KIRK ISDN Interface Card in the slot and mount the two screws from the blind cover.
5
Replace the top cover.
6
Connect an RJ45 cable (not included) between the KIRK ISDN Interface Card on the rear of the
KIRK Wireless Server and the switch.
7
Power up the KIRK Wireless Server 1500 again.
Software and help files are available at www.kirktelecom.com