PYLE Audio PFTL31404.1 - Manual (Page 8)

8
42
6. Touch the Right Handrail (72) to discharge any static.
Press the end of the Upright Wire (42) into the socket in the
bottom of the Console Base (47). The connector should
slide easily into the socket and snap into place. If the
connector does not slide easily and snap into place, turn
the connector and then insert it.
6
72
47
47
5. Set the Console Base (47) on the Right Handrail (72) and
the Left Handrail (71). Attach the Console Base with four
3/4” Screws (2). Start all four Screws before tightening
them; do not overtighten the Screws.
5
2
2
71
72
Small
Hole
71
4
4. Hold the Console Base (47) near the Left Handrail (71).
Attach the ground wire on the Console Base to the small
hole in the side of the Left Handrail with the 1/2” Ground
Screw (75) as shown.
47
75