PYLE Audio PFTL31404.1 - Manual (Page 7)

7
2. Identify the Right Upright (24) and the Left Upright (99).
Straighten the Upright Wire (42), and feed it into the lower
end of the Right Upright (24) and out of the upper end.
Next, hold the Right Upright against the right side of the
Base (69); make sure that the Right Upright is turned
so that the upper end is angled in the direction
shown. Hand tighten two 3” Bolts (37) with one Star
Washer (63) and two Washers (45) into the Base and the
Right Upright; be careful not to damage the Upright
Wire.
With the help of a second person, carefully tip the tread-
mill onto its other side. Attach the Left Upright (99) and
the other Wheel (not shown) as described above and in
step 1. Make sure that the two small holes in the Left
Upright are positioned as shown. Note: There is not
an upright wire on the left side.
42
69
2
24
99
Small
Holes
37
45
63
3. With the help of a second person, carefully tip the tread-
mill so that it is flat on the floor, and raise the Uprights
(99, 24) to the vertical position as shown.
Hold the Crossbar (25) between the Left Upright (99) and
the Right Upright (24). Attach the Crossbar with two 3”
Bolts (37). Firmly tighten the Bolts.
Identify the Right Handrail (72), which has a large round
hole in the location shown. Route the Upright Wire (42)
through the hole in the Right Handrail. Next, hand tighten
a 2 1/4” Bolt (35) into the upper end of the Right Handrail
and the Right Upright (24). Then, hand tighten a Handrail
Bolt (27) with a Washer (45) into the lower end of the
Right Handrail and the Right Upright. Be careful not to
pinch the Upright Wire. Firmly tighten the Bolts.
Attach the Left Handrail (71) in the same way. Note:
There is not an upright wire on the left side.
35
25
37
37
27 45
45
27
35
71
42
72
24
99
Large
Hole
3