Plinius Audio Hautonga Intergrated Amplifier - Manual (Page 20)

18 PLINIUS HAUTONGA
IMPORTANT: DO NOT FIT A FUSE WITH A HIGHER RATING.
In the unusual event that this fuse should blow, you must first establish the cause of
this failure (such as power surges, damaged mains cable, etc) before replacing the
fuse with one of the same rating and type. Should the amplifier continue to suffer
mains fuse failure, contact your Plinius dealer.
OVER TEMPERATURE PROTECTION
The Hautonga Integrated Amplifier is fitted with an auto-reset thermal sensor. The
sensor is located at the main power transformer and should the transformer internal
temperature exceed 110°C (230°F) the power will be disconnected from the unit.
The unit will remain off until the temperate has reduced significantly, and then the
sensor will automatically reset to the ON state.
If Over Temperature Protection occurs you should switch the unit off immediately. Check
the placement of the unit and ensure there is adequate airflow above and around the
unit. Refer to the Placement & Ventilation section on page 4 for further information.