PYLE Audio PT502 - Manual (Page 6)

6- ENG D22724
MAINTENANCE
Lubrication
Air tools require lubrication throughout the life of the tool. The air motor and bearing uses com-
pressed air to power the tool. Because moisture in compressed air will rust the air motor, you must
lubricate the motor daily. An inline oiler is recommended.
To lubricate the air motor manually:
● Disconnect the tool from the air supply holding it so the air inlet faces
up.
● Depress the trigger and place one to two drops of air tool oil in the air
inlet Depressing the trigger helps circulate oil in the motor. NOTE: Use
SAE #10 weight oil if air tool oil is not available.
● Connect the tool to an air source, cover the exhaust end with a towel
and run for a few seconds.
Any excess oil in the motor is immediately expelled
from the exhaust port. Always direct exhaust port
away from people or objects.
Failure to lubricate the tool at the air inlet will void your warranty.