Philips PR0930X4 - Manual (Page 2)

ANT. IN
AC 120V
OR
OR
To either
Antenna Hole
Round cable of
Rod Antenna
to ANT. IN
Round Cable
75
Ω
to ANT. IN
Back of TV
Rod Antenna
(supplied)
Combination
VHF/UHF Antenna
(outdoor or indoor) Twin-lead wire
300 to 75 Ω adapter
to ANT. IN
ANT. IN
AC 120V
OR
UHF
VHF
300 Ω
75
-300
Ω A
D
A
P TE
R
H
OOKING
U
P
Y
OUR
TV (A
NTENNA
/C
ABLE
C
ONNECTIONS
)
A combination antenna or a
rod antenna (supplied)
receives normal broadcast
channels (VHF 2-13 and UHF
14-69). Your connection is easy
since there is only one 75
Ω
(ohm) antenna jack on the
back of your TV - and that’s
where the antenna goes.
A NTENNA
C OMBINATION UHF/VHF To set the
TV to select only
the channel num-
bers in your area,
see Auto Install on
page 5.
If you install the TV
beneath a kitchen
cabinet, you may
push a rod antenna
into the antenna
hole on the bottom
of the TV cabinet
for the best use. See
page four for details
on how to install
the TV under a
kitchen cabinet.
S MART
H ELP
If you install a rod
antenna (supplied), push the
base of the antenna into the
antenna hole on either the left
or the bottom of the TV.
If your antenna has a
round connector (75
Ω
),
then you're ready to connect it
to the TV. Go to step 2.
If your antenna has flat
twin-lead wire (300
Ω
), you
first need to attach the antenna
wires to the screws on a 300
to 75
Ω adapter (not supplied).
Push the round end of
the adapter (cable or rod
antenna) onto the
ANT(enna) IN jack on the
back of the TV. If the round
end of the adapter or cable is
threaded, screw it down tight.
Y ou may have two separate
antennas. One antenna is
for VHF channels (2-13) and
the other antenna is for UHF
channels (14-69).
For homes with separate
UHF/VHF antennas, you will
need an optional combiner
before you can connect the
antennas to the TV.
S EPARATE UHF/VHF
Back of TV
UHF/VHF Combiner
(not supplied)
75-300 Ω Adapter
Outdoor UHF Antenna
(Twin-lead 300 Ω )
Outdoor VHF
Antenna
(Twin-lead 300 Ω )
Twin-lead
Wire
Push the round end of the
combiner onto the ANT(enna)
IN jack on the back of the TV.
Attach the separate
UHF and VHF antennas to
the correct screws on the
combiner (not supplied).
Round
End
Outdoor VHF
Antenna
(Round cable 75
Ω
)
- 2 -
If you installed a rod
antenna, extend the antenna
and adjust its length, direction,
and angle for the clearest pic-
ture.
PR0930x4 3/1/02 10:21 AM Page 2