Peavey Impulse 100P - Manual (Page 13)

13
E En nccllo ossu urre e::
Peavey Impulse 100P (domestic)
FFrre eq qu ue en nccy y rre essp po on nsse e::
80 Hz to 20kHz
LLo ow w ffrre eq qu ue en nccy y lliim miitt ((--3 3 d dB B p po oiin ntt))::
80 Hz
U Usse ea ab blle e llo ow w ffrre eq qu ue en nccy y lliim miitt ((--110 0 d dB B p po oiin ntt))::
63 Hz
IIn ntte errn na all p po ow we err a am mp plliiffiie errss ((@ @ 112 20 0 V VA AC C lliin ne e))::
Woofer - 200 Watts peak dynamic power
150 Watts @ less than 0.1% distortion
Tweeter - 70 Watts peak dynamic power
50 Watts @ less than 0.1% distortion
N No om miin na all S Se en nssiittiivviitty y ((11 W W @ @ 11 M M,, ssw we ep ptt ssiin ne e
iin np pu utt iin n a an ne ecch ho oiicc e en nvviirro on nm me en ntt))::
96 dB
M Ma axxiim mu um m sso ou un nd d p prre essssu urre e lle evve ell::
120 dB music peak
N No om miin na all rra ad diia attiio on n a an ng glle ess::
90˚ horizontal by 45˚ vertical
T Trra an nssd du ucce err C Co om mp plle em me en ntt::
10" premium heavy-duty, long-throw
weather-resistant woofer, and 14XT
™ 1.4"
titanium diaphragm compression driver
tweeter
B Bo oxx ttu un niin ng g ffrre eq qu ue en nccy y ((FFb bo oxx))::
76 Hz
E Elle eccttrro oa acco ou ussttiicc ccrro osssso ovve err ffrre eq qu ue en nccy y::
2000 Hz
C Crro osssso ovve err tty yp pe e::
Internal electronic two-way crossover with
CD horn EQ, level matching, bass boost
and subsonic filtering.
C Crro osssso ovve err S Sllo op pe ess::
18 dB/octave (3rd order) low pass, 18
dB/octave (3nd order) high pass, both
with staggered poles and driver EQ. Unit
has horn spatially aligned with woofer, so
there is no need for phase alignment or
time delay of the signals.
E Elle eccttrro on niicc iin np pu utt iim mp pe ed da an ncce e ((n no om miin na all))::
10 k Ohms unbalanced, 20 k Ohms
balanced
IIn np pu utt cco on nn ne eccttiio on nss::
One combo female XLR/ 1/4" phone jack
and one male XLR all providing balanced
operation, in parallel. Also has a ??"
phone jack based loop-thru that allows
other Impulse 100P units to be linked to a
single unit for signal source and volume
control.
E En nccllo ossu urre e m ma atte erriia allss a an nd d ffiin niissh h::
Injection-molded high-impact
polypropylene of a nominal thickness of
1/4" with internal ribbing and bracing,
and with textured finish. Molded material
is black.
M Mo ou un nttiin ng g::
Subwoofer stand mounting via molded-in
mount, flying via Versamount
™ 35 (top or
bottom of cabinet) and four rubber feet
for floor use.
D Diim me en nssiio on nss::
18.88 in. (47.9 cm) tall (17.63 in./ 44.8 cm
in rear) by x 14.00 in. (35.6 cm) wide
(8.25in./ 21.0 cm in rear) by x 13.13 in.
(33.3 cm ) deep
O Op pttiio on na all a acccce esssso orriie ess::
Impulse 100 floor monitor kit
N Ne ett w we eiig gh htt::
35 lbs.
S Sh hiip pp piin ng g w we eiig gh htt::
A Ad dd diittiio on na all R Re em ma arrk kss::
Also available as a passively crossed-over
unit.
E ELLE EC CT TR RO ON NIIC CS S A AN ND D A AM MP PLLIIFFIIE ER R
S SP PE EC CIIFFIIC CA AT TIIO ON NS S::
E Elle eccttrro on niicc iin np pu utt iim mp pe ed da an ncce e ((n no om miin na all))::
Primary balanced input: 10 k Ohms
unbalanced and 20 k Ohms balanced
LLo oo op p tth hrru u iin np pu utt::
High-Z
IIn nffrra asso on niicc ffiilltte err p prro otte eccttiio on n::
36 dB/octave roll-off
N No om miin na all a am mp plliiffiie err ffrre eq qu ue en nccy y rre essp po on nsse e::
+0, -1 dB from 10 Hz to 30 kHz
H Hu um m a an nd d N No oiisse e::
Greater than 90 dB below rated power
D DD DT T ™ ™ d dy yn na am miicc rra an ng ge e::
Greater than 14 dB
T TH HD D a an nd d IIM M::
Typically less than 0.1 %
D Da am mp piin ng g ffa acctto orr::
Greater than 100 @ 1000 Hz, 8 Ohms
P Po ow we err rre eq qu uiirre em me en nttss o off IIm mp pu ullsse e 110 00 0P P
S Sy ysstte em m ((d do om me essttiicc))::
Nominal 100 Watts, 120 VAC, 60 Hz
P Pe ea av ve ey y IIm mp pu ulls se e ® ® 110 00 0P P
S SP PE EC CIIF FIIC CA AT TIIO ON NS S