Pride Mobility 1170XL Plus 2VHD - Manual (Page 21)

Jazzy 1170 XL Plus Series www.pridemobility.com 21
To install the seat:
1. Make sure the power chair is in drive mode. See
figure 8.
2. Remove the quick release pins from each of the
four seat towers. See figure 9.
3. Set the seat on the seat towers.
4. Install the quick release pins back into the seat
towers.
5. Install the controller into the desired armrest.
6. Plug the controller harness into the connector on
the electronics tray.
7. Route the controller harness so that it cannot be
pinched in the seat hinge.
MANDATORY! Prevent controller
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for the controller harness
to prevent the harness from getting
caught in the drive tires, pinched in
the seat frame, or damaged when
passing through doorways.
8. Secure the controller harness to the armrest
receiver with one or more wire ties. See figure 10.
I V . A S S E M B L Y
Seat Installation
The standard seat installation method incorporates the seat frame and four adjustable seat posts located on the
power base.
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may
lose control of the seat if they do so.
Figure 10. Controller Harness Routing
WIRE TIES