Precor LOW-IMPACT TREADMILLS 9.33 - Manual (Page 77)

9.3x Low-Impact Treadmills Assembly Guide 1
Thank you for choosing Precor. For proper installation, please read this
guide thoroughly and follow the assembly instructions. If you do not
assemble the treadmill according to these guidelines, you could void the
Precor Limited Warranty.
Obtaining Service
You should not attempt to service the treadmill except for minor belt
adjustments and maintenance as described in the owner’s manual. Should
you need more information regarding customer support numbers or a list of
Precor authorized service centers, visit the Precor website at
www.precor.com/cons.
Unpacking the Equipment
The treadmill is carefully tested and inspected before shipment. The unit is
shipped in one box. Ask for help from two or more people to unpack and
assemble the treadmill. If any items are missing, contact your dealer.
Required Tools
• Phillips-head screwdriver
• Crescent wrench
• Bubble level
• Wire cutter
Installation Requirements
Follow these installation requirements when assembling the unit:
• Assemble the unit near the location where you plan to use it.
• Provide ample space around the unit.
Open space around the unit allows for easier access.
• Set up the unit on a solid, flat surface.
A smooth, flat surface under the unit helps keep it level. A level unit has
fewer malfunctions.
• Open the box and assemble the components in the sequence
presented in this guide.
• Obtain assistance.
Ask another capable adult for assistance during the assembly process.
• Use your fingers or the appropriate tools to insert fasteners.
Proper alignment helps alleviate crossthreading. Do not fully wrench
tighten fasteners until instructed to do so.
Important: When wrench tightening, the head of the fastener should be flush
with the product. If it is not, cross-threading has occurred. Do not attempt to
rework the assembly as more damage to the unit will occur. Contact
Customer Support. Refer to Obtaining Service.
• If you plan to move the unit, obtain help and use proper lifting
techniques.
Grasp the one-piece plastic end cap to lift the treadmill and roll it on its
front wheels. Do not grasp any other plastic part while lifting or moving
the unit. The other plastic pasts are not reinforced and they may break.