Pioneer PDR-509 - Manual (Page 37)

37
Additional
Information
Additional Information
Troubleshooting
Below is a list of messages mainly related to playback and recording problems, together with a brief explanation and a page
reference where you can find more information:
Cause
The input signal is digital-copy pro-
tected with
SCMS .
The digital source was interrupted.
The source is not audio, or is an
incompatible format (e.g. a
CD – ROM ).
The source player was already playing
when the
DIGITAL SYNCHRO button was
pressed.
The unit is preparing to record.
The recorder was switched off/
unplugged after recording without
ejecting the disc. The recorder could
not write essential recording informa-
tion onto the disc.
The unit is resuming an operation. If
the power supply is cut off (either by
mistake or due to a power failure)
during recording, the unit enters
resume mode once power is restored
so that additional recording is possible.
No more recording is possible because
the available recording time of the disc
has been used up, or 99 tracks have
already been recorded on the disc.
The loaded disc is a CD – R or CD – RW
disc for professional use without the
CONSUMER USE disignation.
Cause
The disc is damaged or dirty.
The disc is loaded upside down.
A system error occurred, perhaps due
to noise or static electricity.
Remedy
Take out the disc and check for dust, dirt, scratches,
etc. Clean as necessary.
Take out the disc and reload it label-side up.
If the same messages are displayed again after the
disc is reloaded, unplug the power cord and plug it
in again. If the same messages are still displayed,
please contact a Pioneer authorized service center.
Unplug the power cord and plug it in again. If the
same messages are displayed again, please contact
a Pioneer authorized service center.
Display
CHECK DISC
CHECK
(blinking
display)
Display
CAN NOT
COPY
CAN NOT REC
CHECK INPUT
(CD) ?
SET UP
REPAIR
RESUME
REC FULL
Pro DISC
Remedy
Record the source through the analog inputs.
Check that the digital input cable is connected
properly and that the power of the source player is on.
Check that the source is a regular music source.
Stop the source player. After a short time, 1- SYNC or
AL - SYNC is displayed, and the recorder goes into
synchro–record-pause mode.
Wait until the message disappears.
While REPAIR is displayed, the recorder automatically
examines the recorded area of the disc and updates
the track numbers and recording time data. This
process takes about 40 minutes for a fully recorded
disc. Finalization or further recording is possible
once the
REPAIR message disappears.
Wait until the message disappears.
Use another disc, or erase the CD – RW disc.
Load a CD – R or CD – RW disc that is designated as
being for consumer use.
Display messages relating to recording:
Display
NEW DISC
NO DISC
Remedy
Only recording is possible on blank CD – R or CD – RW
discs. Playback is not possible.
Open the tray and check that a disc is loaded.
Cause
A blank disc is loaded.
An attempt is made to start playback
without loading a disc.
Display messages relating to playback:
Reference
p.9
p.15
Reference
p.25, 32
p10
pp.20–22
p.19
p.19
p.8, 19
Reference
p.19
p.15