Pride Mobility 1107 - Manual (Page 24)

24 www.pridemobility.com Jazzy 1107
V . C O M F O R T A D J U S T M E N T S
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to increase your
comfort. These adjustments include seat height and angle, armrest angle, foot platform height and angle, and controller
position. If your power chair is equipped with a Specialty Seat or a Synergy Seat, refer to the information provided in separate
manuals. If your power chair is equipped with a contoured seat, refer to the following information.
WARNING! If your power chair was configured by your authorized Pride Provider, please consult your
healthcare professional before changing the seat position or making any other adjustment. Some
adjustments may degrade your power chair’s performance and safety by changing its center of gravity.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the specifications table for specific component weights before you
disassemble the power chair.
WARNING! Prevent injury. Remove the occupant from the power chair before making any
adjustments/repairs.
Figure 16. Side Trapeze Bar Height Adjustment
Figure 15. Front Trapeze Bar Height Adjustment
You may need the following to make comfort adjustments:
! metric/standard socket set and ratchet
! adjustable wrench
! thread lock
Seat Height and Seat Angle Adjustment
You can change the seat height to one of two positions in 1-in.
increments by raising the front and side trapeze bars. See figures 15
and 16. If you raise or lower either the front trapeze bar or the side
trapeze bars, you can also change the seat base angle (dump).
To change the seat height:
1. Turn off the power to the controller.
2. Disconnect the controller from the power base. See figure 6.
3. Remove the seat from the power base.
4. Loosen the screws that attach the trapeze bars to the seat posts.
See figures 15 and 16.
5. Remove the retaining clips that secure the seat posts to the power
base.
6. Move the trapeze bars up or down to the desired height.
7. Reinstall the retaining clips.
8. Remove each screw from the trapeze bars and apply thread
lock.
9. Reinstall each screw into the trapeze bars and tighten.
10. Reinstall the seat.
11. Reconnect the controller to the power base.
RETAINING
CLIPS
SEAT POST
SEAT POST
RETAINING
CLIPS
SIDE TRAPEZE BARS
FRONT TRAPEZE BAR