Psd-spa installation (figure 3), Psd-bw/l nesting cart storage (figure 4) – Premier Mounts MOUNTS PSD-BWL User Manual

Page 6

PSD-BW/L

Installation Instructions

Page - 6 -

PSD-SPA Installation (Figure 3)

NOTE:

Use of the PSD-SPA will depend on the mount that is used. All PSM/CTM Series mounts require using the PSD-SPA.

The Revolution Series, USA and UFA Mounts, however, do not require the use of the PSD-SPA.

1. Slide the PSD-SPA over and down the support tubes.
2. Once the desired height has been determined, tighten the four (4) M8 x 10mm set screws, using the 5/32” Allen wrench (supplied)

to secure the PSD-SPA (Figure 3).

Figure 3

PSD-BW/L Nesting Cart Storage (Figure 4)

The PSD-BW/L is designed to maximize storage space. When storing multiple carts, slide the Nesting Carts together as close as
possible.
NOTE:

Please adhere to any WARNING statements that will apply to the different mounting configurations the PSD-BW/L

Nesting Cart will be used with.

Figure 4

5/32” Allen Wrench

Support Tubes

PSD-SPA

This manual is related to the following products:

MOUNTS PSD-BW