Pioneer DV-466-S - Manual (Page 68)

Additional information 10
68
En
Setting the TV system
(Except Taiwanese model)
The default setting of this player is AUTO , and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to
AUTO . If you experience picture distor-
tion with some discs, set the TV system to
match your country or region’s system. Doing
this, however, may restrict the kinds of disc
you can watch. The table below shows what
kinds of disc are compatible with each setting
(
AUTO , PAL and NTSC ).
1 If the player is on, press STANDBY/
ON to switch it to standby.
2 Using the front panel controls, hold
down then press STANDBY/ON
to switch the TV system.
The TV system changes as follows:
• AUTO NTSC
• NTSC PAL
• PAL AUTO
The player’s display shows “ Welcome
Pioneer ”, then indicates the new setting.
• You have to switch the player into standby
(press STANDBY/ON ) before each
change.
Watching NTSC on a PAL TV
(MOD. PAL)
Most models of the newly developed count-
down PAL TV system detect 50 Hz (PAL)/60 Hz
(NTSC) and automatically switch vertical
amplitude, resulting in a display without
vertical shrinkage. However, in some cases,
the image may appear without color.
If your PAL TV does not have a V-Hold control,
you may not be able to watch NTSC discs
because of picture roll. If the TV has a V-Hold
control, adjust it until the picture stops
rolling.
On some TVs, the picture may shrink verti-
cally, leaving black bands at the top and
bottom of the screen. This is not a malfunc-
tion; it is caused by the NTSC to PAL conver-
sion.
Disc Player setting
Type Format NTSC PAL AUTO
DVD NTSC NTSC MOD.PAL NTSC
/Super VCD PAL NTSC PAL PAL
Video CD NTSC NTSC MOD.PAL NTSC
PAL NTSC PAL PAL
CD/no disc — NTSC PAL NTSC or
PAL
DV260.book 68 ページ ２００３年１月２８日 火曜日 午後７時２０分