Pride Mobility JET 3 - Manual (Page 45)

Jet 3 Ultra www.pridemobility.com 45
A P P E N D I X I - S P E C I F I C A T I O N S
1 Varies with base model, user weight, terrain type, battery amp-hour rating (Ah), battery charge, battery condition, motors, controller
type, tire type, and tire condition. This specification can be subject to variance of (+ or -) 10%.
2 Due to manufacturing tolerances and continued product improvement, this specification can be subject to variance of (+ or -) 3%.
3 Tested in accordance with ASNI/RESNA, WC Vol 2, Section 4 & ISO 7176-4 standards. Results derived from theoretical calculations
based on battery specifications and drive system performance. Test conducted at maximum weight capacity.
4 AGM or Gel-Cell type required. See VI. “Batteries and Charging.”
5 Battery weight may vary based on battery manufacturer.
NOTE: This product conforms to all applicable ANSI/RESNA testing requirements and ISO 7176 series
EN12184 standards. All specifications subject to change without notice.
JET 3 ULTRA SPECIFICATIONS
Suspension: Active-Trac
Drive Wheels: 10 in. (25.4 cm) pneumatic or solid available
Caster Wheels: 8 in. (20.32 cm) solid, rear-mounted
Anti-tip Wheels: 6 in. (15.24 cm) solid, front-mounted
Maximum Speed: 1 Up to 4 mph (6.44 km/h)
Range: 1,3 Up to 11 miles (17.7 km)
Brakes: “Intelligent Braking” electronic regenerative, disc park brake
Ground Clearance: 2 See figure 29.
Turning Radius: 2 See figure 29.
Overall Size: 2 Length: See figure 29.
Width: See figure 29.
Drivetrain: Two motor, mid-wheel drive
Batteries: 4,5 Two 12-volt, deep-cycle, U-1
Battery Charger: 3-amp, off-board
Weight Capacity: 300 lbs. (136 kg)
Component Weights: 2 Base: 92 lbs. (41.74 kg)
Medium-back Seat: 37 lbs. (16.78 kg)
Batteries: 24.5 lbs. (11.11 kg) each