Remote control functions – Plinius Audio Anniversary Integrated Amplifier User Manual

Page 12

INTEGRATED AMPLIFIER

Remote Control Functions

The Plinius Anniversary Integrated Amplifier features a full function remote to control all
settings and configurations of the amplifier as well as complete controls for operating
the Anniversary CD player.

INTEGRATED AMPLIFIER REMOTE FUNCTIONS:

1. STANDBY
Standby is used to put the unit into a low power mode. This
disconnects the outputs of the Integrated Amplifier and turns off
the white display LED’s. It also switches the integrated amplifier to
a low bias mode to reduce power consumption and still keep the
circuitry active. This allows a minimum warm up period before the
Plinius Anniversary Integrated Amplifier is at it’s sonic best.

2. DISPLAY
The display button on the remote enables you to adjust the
display brightness of the white LED’s. Pressing the display button
repeatedly will dim the LED in steps until they are off. The next
press of the button will cycle the display back to full brightness.

3. SOURCE SELECTION
The source selection buttons enable changing from one input to
another when needed and can be scrolled left or right to select the
desired source. On reaching the left most or right most input, the
selection will scroll in a continuos loop with the next button press.

4. HT BYPASS
The HT Bypass button activates the Plinius Anniversary Integrated
Amplifier home theatre bypass mode. Once activated, the
preamplifier is bypassed and the signal is transmitted from the HT
Bypass input directly to the power amplifier. NOTE: In HT Bypass
mode the only buttons that continue to function are Standby
and Display. More information on HT Bypass can be found in the
Installation & Operation section in this manual.

5. VOLUME CONTROL
Use these two buttons to control the volume level of the Integrated Amplifier. The
right side button increases volume, while the left side button decreases the volume.
Briefly press either button to make fine adjustments to the volume level. Hold down
either button to continually adjust the volume level.