Philips 14 PV 274 - Manual (Page 9)

7
Programming with ’VIDEOPlus+’
All the information required for programming is contained
encoded in the ’VIDEOPlus+’ code.
1 Press the SV/V+ button on the remote control.
2 Enter the entire ’VIDEOPlus+ code’. This code (up to 9
digits) is found next to the start time of a TV programme
in your TV guide.
If you entered an incorrect code number, clear it with the
CLEAR b button.
VIDEOPLUS
CODE
DAILY/WEEKLY
ONCE
PROGRAMME NR. 01
x y 0-9 OK
3 If you want to repeat programming at daily or weekly
intervals, select the required setting in the
’DAILY/WEEKLY’ line.
’Daily’ programming can only be used for recordings to
be made from Mondays to Fridays inclusive.
4 After the confirmation the corresponding data appear on
the TV screen.
Note: If you use ’VIDEOPlus+’ for the first time, the
’PROGRAMME NR.’ line appears when you enter the
’VIDEOPlus+’ code. Enter the required programme num-
ber for this TV channel.
DATE DW PR START END d
01 01 17:15 18:45
v w x y 0-9 OK
5 Confirm with the OK button.
The data has been stored in a TIMER block.
Please ensure that you loaded a cassette without erase
protection.
6 Press the STANDBY m button.
How to enter, check or clear a TIMER
block manually
1 Press the TIMER k button.
2 Select a free TIMER block or the TIMER block you want
to check or clear.
3 Clear: Press the CLEAR b button.
4 Enter/Check: Press the D or C button to switch
between ’DATE’ (date), ’DW’ (daily, weekly), ’PR’
(programme number), ’START’ (start time) and ’END’
(end time).
Press the
A and the B or the 0-9 buttons to
change the data.
5 To end programming, press the MENU button.
6 Press the STANDBY m button.
Important notes for programmed recordings
• If the message ’PLEASE PRESS STOP’ or ’PLEASE PRESS
STANDBY’ appears on the TV screen, press the
STOP h or the STANDBY m button.
A TIMER recording will only function, if the set isn’t used
for other videorecorder functions (e.g. playback).
• The TIMER lamp on the front of the set lights up when
one or more of the TIMER blocks are occupied.
• If the end of the cassette is reached during a recording,
the video recorder automatically ejects the cassette. The
set switches off after a few minutes.
• If you forget to load a cassette, ’NO CASSETTE CANNOT
RECORD’ will appear.
• If you inserted a cassette with erase protection when you
want to start a recording, the cassette will be ejected.
• If ’CODE ERROR’ appears on the TV screen, you entered
an incorrect code number or the incorrect date. Repeat
the entry or end with the
STANDBY m button.
With ’Daily’ programming, the first recording must take
place within a week.
• If ’DAILY ERROR’ appears on the TV screen, the date was
incorrectly entered. ’Daily’ programming can only be used
for recordings to be made from Mondays to Fridays
inclusive.
• The programmed recording will always be made at the
recording speed (SP/LP) that has already been selected
on the TV Combi.