PYLE Audio PWMA100 - Manual (Page 3)

1. POWER SUPPLY
a. AC power: Please confirm your current AC power is
same as the voltage marked on the device.
b.DC power: DC power can be input from DC IN jack. If you
use car battery, the power should be 12V-15V. Please
note the correct polarity.
C. Built-in rechargeable battery: you can also use built-in
rechargeable battery.
2. Turn on power switch of amplifier, power indicator will light.
3. Open the battery cover of the transmitter. Put a 9V battery
into battery compartment and then close the battery cover.
Keep transmitter at least 1M from the receiver to prevent
feedback. Turn on transmitter, RF indicator on receiver will
light. Adjust wireless microphone volume to suitable level.
The wireless system is now ready to use.
4. Wired MIC can connect to MIC in jack and its volume can
be adjusted separately. Wire microphone and wireless
microphone can be used at the same time.
5. Adjust TREBLE/BASS to suitable level. When feed-back
comes from amplifier, please reduce TREBLE. If feedback
still exists, reduce the volume slightly.
6. REC OUT can connect to recorder player or external
amplifier.
1. Connect amplifier to AC power, charge indicator will light.
The unit starts to charge rechargeable battery. DC power
can not charge the battery.
2. During charging you can use the unit at the same time.
3. When using rechargeable battery, if the unit stops
producing sound, this means the rechargeable battery
power is low. Connect AC power to charge the battery.
Charging time is about 8~10 hours.
4. Please charge this device every 2 months if you don't use
the device for a long period of time.
5. Unplug th unit from mains power supply if you are not
going to use this device for a long time or after charging.
OPERATION OPERATION
Recharging:
-3- -4-