Philips GOGEAR SA080308 - Manual (Page 10)

10 EN
Battery level indication
The display indicates the approximate levels of
the battery status as follows:
100% 75% 50% 25% 0%
A flashing battery screen indicates
»
that the battery is low. The player
saves all settings and switches off
within 60 seconds.
Note
Rechargeable batteries have a limited number •
of charge cycles. Battery life and number of
charge cycles vary by use and settings.
The charging animation stops and the
•
icon is displayed when the charging process is
completed.
To conserve battery power and increase the
play time, do the following on SA080:
Set the backlight timer to a low value •
(go to > [Display settings] >
[Screen off timer]).
First-time setup
The first time you connect SA080 to a PC,
install Philips Device Manager on the PC. Over
the Internet, you can update the firmware of
the player through Philips Device Manager.
When you connect the SA080 to the PC for
the first time, a pop-up window appears:
1
Select InstallPhilips Device Manager.
2
Follow the on-screen instructions to
complete the installation of the software.
Note
The installation requires you to agree to the •
license terms.
3 Get started
Charge power
SA080 has a built-in battery that can be
charged through the USB port of a computer.
As shown, connect the SA080 to a PC by using
the USB cable.
Note
When you connect • SA080 to a computer,
you are briefly prompted to select: [Charge &
transfer] or [Charge & play].
• SA080 automatically applies [Charge &
transfer], if no new selection is made.
EN