Philips DVD624 - Manual (Page 12)

12 Hookups (cont’d)
Connecting to a TV Only
TV has Component Video In Jacks (red, green, and blue)
Back of TV
(example only)
LEFT AUDIO IN
RIGHT AUDIO IN Pr/Cr
Y
Pb/Cb
LEFT AUDIO IN
RIGHT AUDIO IN Pr/Cr
Y
Pb/Cb
1
2
3
1 Connect the DVD Player’s Y C B C R (VIDEO OUT) jacks to
the corresponding COMPONENT VIDEO IN jacks on the
TV. Use component video cable (not supplied).
2 Connect the DVD Player’s red and white AUDIO OUT (left
and right) jacks to the left/right AUDIO IN jacks on the TV.
Use the supplied audio cables. Match the cable colors to the jack
colors.
3
Plug the power cords of the DVD Player and the TV into an
active power outlet. Press the POWER ON/OFF button on
the front of the DVD Player to turn on the DVD Player.
4 Turn on the TV power. Set the TV to the correct
Component Video In channel. See your TV owner’s manual for
details. Or, change channels at the TV until you see the DVD screen
saver on the TV.
• On the TV, the component
video in jacks may be labeled
YUV or Pr/Cr Pb/Cb Y and may
be green, blue, and red.
• Set VIDEO OUTPUT to YCBCR.
Details are on page 34.
• If your TV has a single Audio In
jack instead of separate left/right
Audio In jacks, you will need a
different audio cable. You need a
“splitter” audio cable to go from
the left/right AUDIO OUT jacks
of the DVD Player to the single
Audio In jack on your TV. See
your electronics retailer for
details.
Helpful Hints