Pioneer PDK-WT02 - Manual (Page 12)

12
En
Adjusting the Angle
This installation hardware allows the display to be directed downwards freely at any angle from the vertical to 25°.
This adjustment must always be done by 2 people.
Adjust the angle by rotating the screws at the center top and center bottom of the wall side hardware to the left or right.
Note
If the angle is increased while you are adjusting the angle using the screw at the center of the bottom, it is difficult to turn the
screw. When this happens, adjust it at the center of the upper.
Turn the screws very carefully to avoid damaging the wall.
When a screw becomes tight at either end of the adjustment range, do not turn the adjustment screw any further, because if
you do, you will apply excessive force, deforming the screw.
A
B
Opening
Closing
Hexagon wrench
End face of the plate
Notch
Matched in both
directions
Overlapped
Resin
plate
PDP side
hardware
(Surface where
the spacer is
attached)
Measuring the opening distance X
enables approximate angle values to
be determined.
X
When it is in this state, do not turn
the adjustment screw any further in
the closing direction.
B When inclined at 25°
When it is in this state, do not turn the
adjustment screw any further in the
opening direction.
Resin plate
A When vertical (side view)
Tilt Angle Criteria
X
Angle
5° 192 (7-9/16) 188 (7-13/32) 191 (7-17/32) 212 (8-11/32)
10° 246 (9-11/16) 238 (9-3/8) 244 (9-19/32) 262 (10-5/16)
15° 298 (11-23/32) 287 (11-5/16) 296 (11-21/32) 310 (12-7/32)
20° 348 (13-11/16) 334 (13-5/23) 346 (13-5/8) 357 (14-1/16)
Standard holes of
50-inch model
Standard holes of
43-inch model
Upper holes of
43-inch model
One body type
standard hole
Specifications
External dimensions 740 (W) x 573 (H) x 67 (D) mm (29-1/8 (W) x 22-9/16 (H) x 2-5/8 (D) inch)
Weight 13.8 kg (30.4 lbs)
• The above specifications and exterior may be modified without prior notice to improve the product.
Angle of incline and appearance of the screw for angle adjustment
from a horizontal position on the front
Standard hole Upper hole
PDP-506XDE
23° or more visible to 25° invisible PDP-506FDE
PDP-506HDG
PDP-436XDE
16° or more visible 22° or more visible PDP-436FDE
PDP-436HDG
One body type
15° or more visible 21° or more visible
plasma display
Unit: mm (inch)