Philips AC4054 - Manual (Page 7)

Always unplug the appliance after use and before you clean it.
Do not use the appliance in a room with major temperature changes, as this may cause
condensation inside the appliance.
To prevent interference, place the appliance at least m away from electrical appliances that
use airborne radio waves such as TVs, radios and radio-controlled clocks.
The appliance is equipped with a safety device. If you have not placed the particle filter, the
gas filter and the front panel properly, you cannot switch on the appliance.
If the indoor air quality is poor (e.g. due to smoking or cooking or after renovation), we
strongly advise you to open windows when you use the appliance to improve the air
circulation.
The appliance is only intended for household use under normal operating conditions.
Do not use the appliance in wet surroundings or in surroundings with high ambient
temperatures, such as the bathroom or kitchen.
The appliance does not remove carbon monoxide (CO).
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
Before first use
Placing the gas filter
The appliance comes with all filters, except the gas filter, fitted inside.
Tip: Place the appliance against a wall for better stability when you remove or insert filters.
Note: Make sure you insert the filters in the correct position (with the arrow facing upwards).
Note: The appliance is equipped with a safety device. If you have not placed the particle filter, the gas
filter and the front panel properly, you cannot switch on the appliance.
1 Place your fingers in the recesses of the side panels. (Fig. 2)
Gently pull the top part of the front panel off the appliance (1) and then lift the panel
upwards to remove it (2) (Fig. 3).
To remove the particle filter, grab the filter handles on both sides and gently slide the filter
out of the appliance. (Fig. 4)
Remove all packaging material from the gas filter and slide the filter into the
appliance. (Fig. 5)
You can only insert the gas filter after you have removed the particle filter.
5 To insert the particle filter, slide it into the appliance (‘click’) (Fig. 6).
6 To reattach the front panel, insert the bottom edge first (1) and then press the top part
home (2) (Fig. 7).
using the appliance
AC4064/AC4054
1 Put the plug in the wall socket
The standby light goes on (Fig. 8).
Press the function selection button one or more times to select the required function and
setting (Fig. 9).
The corresponding light goes on and the standby light goes out.
,
,
,
,
,
,
,
,
,
,
English 7