ProForm PFEX33790 - Manual (Page 5)

5
68
71
71
73
41
62
1
3
1
1. Loosen the Lock Knob (68) on the right side of the
Frame (1). Slide the Seat Frame (3) out until it
stops. Tighten the Lock Knob.
Identify the Rear Stabilizer (73), which has Wheels
(41) on the ends. Attach the Rear Stabilizer to the
Seat Frame (3) with two M10 x 70mm Carriage Bolts
(62) and two M10 Nylon Locknuts (71).
2. Attach the Front Stabilizer (72) to the Frame (1) with
two M10 x 70mm Carriage Bolts (62) and two M10
Nylon Locknuts (71).
3. Attach the Upright (2) to the Frame (1) with three
M10 x 25mm Button Screws (25) and three M10
Split Washers (26). Be careful not to pinch the
Reed Switch Wire (13) or the Resistance Cable
(10).
4. Attach the Handlebar (4) to the Upright (2) with two
M6 x 25mm Hex Screws (14) and two M6 Split
Washers (67), but do not tighten the Screws yet.
Make sure that the Screws are threaded into the
indicated holes. Note: Two additional Screws will
be attached in step 6.
3
2
26
26
25
25
25
1
10
13
4
2
14
14
67
67
4
2
62
72
1
71