Philips AJ7040D - Manual (Page 12)

6
Set clock
1 In standby mode, press and hold SET
TIME for two seconds to activate clock
setting mode.
The hour and minute digits begin to
»
blink.
2 Press / and / repeatedly to set
the hour and minute.
3 Press SET TIME to conÀ rm.
» [12H] or [24H] begins to blink.
4 Repeat Steps 2-3 to select 12/24 hour
format.
The set time is displayed.
»
Note
When iPod/iPhone is connected, the clock •
radio synchronizes time from the iPod/iPhone
automatically.
Turn on
Press .
The clock radio switches to the last
»
selected source.
Tip
To select a source, press • SOURCE repeatedly
or the source selection buttons on the remote
control.
Switch to standby mode
Press again to switch the clock radio to
standby mode.
The clock (if set) appears on the
»
display panel.
3 Get started
Always follow the instructions in this chapter in
sequence.
Install remote control battery
Caution
Risk of explosion! Keep batteries away from •
heat, sunshine or À re. Never discard batteries
in À re.
Danger of explosion if battery is incorrectly
•
replaced. Replace only with the same or
equivalent type.
The battery contains chemical substances, so it
•
should be disposed of properly.
Keep children away from the battery.
•
Perchlorate Material - special handling may •
apply. See www.dtsc.ca.gov/hazardouswaste/
perchlorate.
For À rst-time use:
Remove the protective tab to activate the
battery.
To replace the battery:
C
Connect power
D
Caution
Risk of product damage! Ensure that the •
power voltage corresponds to the voltage
printed on the back or underside of the clock
radio.
Risk of electric shock! When you unplug the
•
AC adapter, always pull the plug from the
socket. Never pull the cord.
Warning
To reduce the risk of À re or electric shock, •
do not expose this clock radio to rain or
moisture.
EN