Philips DVP3200V/75 - Manual (Page 2)

The region code for this set is 4.
Since it is usual for DVD movies to be released
at different times in different regions of the
world, all players have region codes and discs
can have an optional region code. If you load a
disc of a different region code to your player,
you will see the region code notice on the screen. The disc
will not playback, and should be unloaded.
Manufactured under license from Dolby Laboratories. “Dolby”
and the double-D symbol are trademarks of Dolby Laboratories.
Copyright Notice
The making of unauthorised copies of copy-protected material,
including computer programmes, files, broadcasts and sound
recordings, may be an infringement of copyrights and constitute
a criminal offence.This equipment should not be used for such
purposes.
This product incorporates copyright protection technology
that is protected by U.S. patents and other intellectual property
rights. Use of this copyright protection technology must be
authorized by Macrovision, and is intended for home and other
limited viewing uses only unless otherwise authorized by
Macrovision. Reverse engineering or disassembly is prohibited.
2
General Information
Thank you for purchasing this Philips DVD/ VCR.This Owner’s
Manual explains the basic operation of this unit.
Environmental Information
All unnecessary packaging has been omitted.
Packaging has been made easy to separate into three materials:
cardboard (box), polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet).
Your unit consists of materials which can be
recycled and reused if disassembled by a
specialised company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old equipment.
Supplied Accessories
• Remote control • Batteries (two AAA size) for Remote control
• AV Cable • RF Coaxial cable • Owner’s Manual
• Quick Start Guide • Warranty Card
Safety Information
• To reduce the risk of fire or electric shock, do not expose
this device to rain or moisture.
• Before operating the unit, check that the operating voltage
indicated on the typeplate (or the voltage indication beside
the voltage selector) is identical with the voltage of your local
power supply. If not, please consult your dealer.
• Place the unit on a flat, hard and stable surface.
• Do not place any combustible objects on the device (candles,
etc.).
• There must be sufficient room in front of the unit for the
disc tray to be opened.
• In cabinet, allow about 2.5cm (1inch) of free space all around
the unit for adequate ventilation.
• Do not expose the unit to extreme of temperature or
humidity.
• If the unit is brought directly from a cold to a warm location,
or is placed in a very damp room, moisture may condense on
the lens of the disc unit inside the unit. Should this occur, the
unit would not operate normally. Leave the unit on for about
one hour with no disc in the unit until normal playback is
possible.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
• Never spill liquid of any kind on this unit. If liquid is spilled
into the unit, consult qualified service engineer.
• Do not stand the unit up vertically. Install the unit in a
horizontal and stable position.
• Be sure to remove the disc and unplug the AC power cord
from the output before carrying the unit.
• When the unit is switched to Standby mode, it is still
consuming some power. To disconnect the
system from the power supply completely, remove
the AC power plug from the wall socket.
• The mains plug shall remain readily operable.
Notice for the progressive scan outputs
Consumers should note that not all high definition television
sets are fully compatible with this product and may cause
artifacts to be displayed in the picture. In case of picture
problems with 525 or 625 progressive scan output, it is
recommended that the user switch the connection to the
‘standard definition’ output. If there are questions regarding
your TV set compatibility with this 525p or 625p DVD player,
please contact our customer service centre.
Introduction
Laser safety
This unit employs a laser. Due to possible eye injury, only a
qualified service person should remove the cover or attempt
to service this device.
USE OF CONTROLS OR ADJUSTMENTS OR
OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULT IN HAZARDOUS
RADIATION EXPOSURE.
4
For Customer Use:
So that you can identify your machine for service questions
or in the event of theft, enter the serial number here.The
serial number (PROD. NO.) is printed on the type plate
fixed at the back of the device.
Model No. DVP3200V
Serial No. ________________________________________
LASER
Type
Semiconductor laser GaAlAs
Wave length 655 nm (DVD)
790 nm (VCD/CD)
Output Power 0.8 mW (DVD)
0.5 mW (VCD/CD)
(WARNING
LOCATION:
ON THE
BACKPLATE OF
SET) CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
KLASS 1 LASER APPARAT
CLASSE 1 PRODUIT LASER
About the PBC Function of Video CD
• This unit conforms to ver.1.1 and ver.2.0 of VIDEO CD
standard, with PBC function.
Ver.1.1 (without PBC function):You can enjoy playback picture
as well as music CD.
Ver.2.0 (with PBC function):When using a VIDEO CD with
PBC function, “Pbc” appears on
the display.
• “PBC” stands for Play Back Control.
• Video CD with PBC function has its original menu. Menu
operation may vary depending on the disc. Refer to the
manual included in the disc for details.
• “Pbc” appears on the front panel display when a Video CD
with PBC function is loaded.
Note:
This unit can be used only where the power supply is AC
230V-240V, 50Hz. It cannot be used elsewhere.
FOR YOUR SAFETY (in Australia):
Install any external aerial to AS 1417.1
E8B23AD_EN 5/16/06 12:03 PM Page 2