Philips DVD615AT99 - Manual (Page 12)

12 Hookups (cont’d)
Connecting to a TV Only
TV has Component Video In Jacks (green, blue, and red)
Back of TV
(example only)
LEFT AUDIO IN
RIGHT AUDIO IN Pr/Cr
Y
Pb/Cb
LEFT AUDIO IN
RIGHT AUDIO IN Pr/Cr
Y
Pb/Cb
1
2
3
Y
Pb
Pr
VIDEO
OUT
1 Connect the Player’s green, blue, and red Y Pb Pr (VIDEO
OUT) jacks to the corresponding COMPONENT VIDEO IN
jacks on the TV. Use component video cable (not supplied).
2 Connect the Player’s red and white AUDIO OUT (right
and left) jacks to the right/left AUDIO IN jacks on the TV.
Use the supplied audio cables. Match the cable colors to the jack
colors. The red jack is the Right audio channel and the white jack is
the Left audio channel.
3 Plug the power cords of the Player and the TV into an
active power outlet.
Press down POWER ON/OFF on the front of the Player to
turn on the Player.
4 Turn on the TV power. Set the TV to the correct
Component Video In channel. See your TV owner’s manual for
details. Or, change channels at the TV until you see the blue Philips
DVD background screen or the Player’s screen saver on the TV.
• On the TV, the component
video in jacks may be labeled
YUV or Y Pb/Cb Pr/Cr and may
be green, blue, and red.
• Set VIDEO OUTPUT to YPBPR.
Details are on page 34.
• If your TV has a single Audio In
jack instead of separate
left/right Audio In jacks, you will
need a different audio cable.
You need a “splitter” audio
cable to go from the left/right
AUDIO OUT jacks of the Player
to the single Audio In jack on
your TV. See your electronics
retailer for details.
Helpful Hints