Philips CTS4000/05 - Manual (Page 33)

English
EN 33
Ad
ju
st
se
tt
in
g
s
[ HDMI Audio ]
When you connect this unit and TV with
HDMI cable, select the audio output
setting for this connection.
[ On ] • – the sound is output through
both your TV and this speaker system.
If the audio format on the disc is not
supported, it will be downmixed to
two-channel sound (linear-PCM).
[
• Off ] – disable audio output from
your TV. The sound is only output
through this speaker system.
[ Audio Sync ]
Set the default delay time for audio output
when you play a video disc.
To start, press 1. OK.
Press 2. b B to set the delay time.
Press 3. OK to confi rm and exit.
[ Night Mode ]
Make loud sound level softer and soft
sound level louder so that you can watch
the DVD movies at a low volume, without
disturbing others.
Note
This setting is only applicable to Dolby Digital •
encoded DVD.
[ • On ] – for quiet viewing at night
(DVDs only).
[
• Off ] – enjoy surround sound with a
full dynamic range.
[ CD Upsampling ]
Convert the music CD to a higher
sampling rate using sophisticated digital
signal processing for better sound quality.
[ • Off ] – turn off CD-upsampling.
[ • On ] – convert the sampling rate of
the CDs twice as high as the original
rate.
Video setup
1
Press OPTIONS.
[ General Setup ] menu is displayed.
2
Press V to select [ Video Setup ], then
p
ress B.
3
Select an option, then press OK.
Video Setup
HDMI Setup
TV Display
TV Type
Picture Setting
Closed Caption
See the explanations of the above •
options in the following pages.
4
Select a setting, then press OK.
To return to the previous menu, press •
BACK.
To exit the menu, press
• OPTIONS.
1_cts4000_12_eng3.indd 33 1_cts4000_12_eng3.indd 33 10/6/2008 10:53:59 AM 10/6/2008 10:53:59 AM