Pacific Cycle CUCINA HR7633 User Manual

Page 10

Stingray Scooter Fork Assembly

Step #1
Insert one fork leg through the lower crown, and slide it up until it contacts the bolt in the upper crown. Push the leg
up to remove the red stop sign decal from the fork leg. Using a 5mm hex (Allen) wrench align the upper crown bolt
with the fork leg, and tighten upper crown bolt completely into the fork leg. Repeat for other fork leg.

ART

ASSEMBL

Basic Maintenance

The following procedures will help you maintain your scooter for years of enjoyable riding.

For painted frames, dust the surface and remove any loose dirt with a dry cloth. To clean, wipe with a damp cloth
soaked in a mild detergent mixture. Dry with a cloth and polish with car or furniture wax. Use soap and water to clean
plastic parts and rubber tires. Chrome plated bikes should be wiped over with a rust preventative fluid.

Store your scooter under shelter. Avoid leaving it in the rain or exposed to corrosive materials. Riding on the beach or
in coastal areas exposes your scooter to salt which is very corrosive. Wash your scooter frequently and wipe or spray
all unpainted parts with an anti-rust treatment. Make sure wheel rims are dry so braking performance is not affected.
After rain, dry your scooter and apply anti-rust treatment.

If the hub and bottom bracket bearings of your scooter have been submerged in water, they should be taken out and
re-greased. This will prevent accelerated bearing deterioration.

If paint has become scratched or chipped to the metal, use touch up paint to prevent rust. Clear nail polish can also
be used as a preventative measure.

Regularly clean and lubricate all moving parts, tighten components and make adjustments as required. (Refer to
Parts 4 and 5 of this manual for further details). The use of alloy components and BED, SATIN and TITANIUM surface
treatments minimizes the number of places where rust can surface.

Storage

Keep your scooter in a dry location away from the weather and the sun. Ultraviolet rays may cause paint to fade or
rubber and plastic parts to crack. Before storing your scooter for a long period of time, clean and lubricate all compo-
nents and wax the frame. Deflate the tires to half pressure and hang the scooter off the ground. Don't store near
electric motors as ozone emissions may effect the rubber and paint. Don't cover with plastic as "sweating” will result
which may cause rusting. Please notice that your scooter warranty does not cover paint damage, rust, corrosion, dry
rot or theft.

Step #2
Align the two fork legs so that the axle dropouts
face forward. Install front wheel, making sure that
the step washers seat into the fork dropouts as
you tighten the axle nuts. Tighten front axle nuts
completely using 15mm wrench.

Upper Fork Crown

Lower Fork Crown

Fork Leg

Remove Decal