Chapter 2, Setting up and using your palm modem® accessory, Installing the batteries – Palm Handbook User Manual
Page 7: Replacing batteries, Setting up and using your palm modem, Accessory
Chapter 2
Page 3
Chapter 2
Setting Up And Using Your Palm
Modem
®
Accessory
Before you use your Palm Modem
®
accessory, you must:
■
Install the batteries.
Note: The batteries may already be installed.
■
Attach your modem to your organizer.
■
Connect an analog phone cable to your modem.
■
Configure your computer.
■
Configure your organizer.
Installing the batteries
To use your modem, you must first
install two AAA alkaline batteries.
The batteries fit in the compartment
behind the battery door on the front
of the modem. Make sure to click the
door into place after installing the
batteries.
Note: A diagram in the interior of
the battery compartment
shows the orientation of the
positive (+) and negative (-)
ends of the batteries. When
correctly installed, the clips in
the battery compartment
secure the batteries in place.
Replacing batteries
Under normal conditions, the AAA batteries provide up to five hours
of continuous use. When your modem has approximately four
minutes of battery life remaining it will sound three short beeps,
which repeat every minute until the batteries are drained. Replace the
batteries as soon as possible.