beautypg.com

600 specifications – Peavey MP 600 User Manual

Page 8

background image

NOTE: All specifications are typical unless otherwise
noted.

0 dBV = 1 Volt RMS
0 dBu = .778 Volts RMS

All specs are referenced to nominal output level (0 dBv)
unless otherwise noted.

All measurements are wideband 20 Hz to 20 kHz unless
otherwise noted.

All control settings are nominal (50% rotation) unless
otherwise noted.

CHANNEL:

Equivalent Input Noise:

-114 dBu @ 40 dB Max Gain

Frequency Response:

(To Speaker Outputs)
± 3 dB 20 Hz to 20 kHz

Distortion: @ (1 kHz)

Less than .009%

Input Impedance:

Low Z Bal. 2K ohms
1/4" Mic/Line Input 22K ohms

CHANNEL EQ:

High EQ:

± 15 dB @ 10 kHz Minimum
Center Detent flat ±2 dB

Low EQ:

± 15 dB @ 100 Hz Minimum
Center Detent flat ±2 dB

Nominal Channel Gain:

Line = 0 dB
Low Z = 30 dB

Maximum Channel Gain:

Low Z = 50 dB
Line = 19 dB

Nominal Input Level:

Low Z = -28 dBu
Line = +2 dBu

Minimum Input Level:

Low Z = -48 dBu
Line = -17 dBu

Maximum Input Level:

Low Z = -9 dBu
Line = +30 dBu

Phantom Power:

+15 VDC

MASTER:

Gain:

Main: = 10 dB (variable)

High EQ:

± 12 dB @ 10 kHz Minimum
Center Detent flat ±2 dB

High Mid EQ:

± 12 dB @ 2 kHz Minimum
Center Detent flat ±2 dB

Low Mid EQ:

± 12 dB @ 300 kHz Minimum
Center Detent flat ±2 dB

Low EQ:

± 12 dB @ 40 HZ Minimum
Center Detent flat ±2 dB

Maximum Output Level:

Main: = + 20 dBu (8.0 V RMS)
Effects: = + 20 dBu (8.0 V RMS)

Nominal Headroom:

Main: = 18 dB
Effects: = 18 dB

Output Impedance:

Main: = 100 ohms
Effects: = 100 ohms

Output Noise:

Residual: -93 dBu

(Master Level Down)

Bus: -91 dBu

(Master Nominal, All Channel Level Full CCW, Reverb Level
Down)

Nominal: -76 dBu

(All Controls Nominal, Low Z Input Terminated 150 Ohms)

Signal to noise ratio:

Microphone input to speaker output (>80 dB)
Frequency Response: 20 Hz to 20 kHz

SYSTEM DYNAMIC RANGE:

95 dB

POWER AMP SECTION:

Frequency Response:

+0, -3 dB, 30 Hz to 28 kHz @ Rated Power

Rated Power and Load:

80 W RMS into 4 ohms
55 W RMS into 8 ohms

THD less than .5% Mic input to speaker output 1 kHz at rated
power.

Speaker system Impedance: 4 ohms minimum.

Power Requirements:

150W @ 100V, 120V, 230 VAC 50/60 Hz

MP

600

SPECIFICATIONS

8

Specifications subject to change without notice.