Pioneer DVD / CD WRITER - Manual (Page 5)

5
English
En
SAFETY INSTRUCTIONS
To ensure your personal safety and to maximize the full operating potential of your drive, read and follow these
safety notices:
ENVIRONMENT - DO NOT expose the unit to excessive dust, high temperature, or high humidity. Please
avoid subjecting the unit to vibrations or shocks.
POWER - Turn OFF your system before installating hardware devices.
READ & RETAIN INSTRUCTIONS - Read all safety and operating instructions before installing the drive.
FOLLOW INSTRUCTIONS - Follow all operating and use instructions.
HEED WARNINGS - All warnings must be adhered to.
CLEANING - DO NOT use liquid, aerosol cleaners, or alcohol on the dirve. Use only a damp cloth to clean
the exterior housing.
WATER AND MOISTURE - DO NOT use this product near water.
POWER SOURCES - Operate this product from the type of power source indicated on the label. If you are
not sure of the type of power available, consult an authorized Pioneer dealer.
OVERLOADING - DO NOT overload wall outlets and extension cords. Doing so can result in fire or electric
shock.
OBJECT AND LIQUID ENTRY - Never push objects of any kind into this product. Touching dangerous voltage
points may cause a short resulting in fire or electric shock. Do not spill liquid of any kind on this product.
CONDENSATION - If the drive is moved from a cool environment to a warmer location, moisture can form
inside of the mechanism causing performance issues. If you are moving the unit to a location with a warmer
temperature, let the product stand for 1 to 2 hours at the new site before turning it ON.
SERVICING - Do not attempt to repair this product yourself. Opening or removing covers may expose you to
dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
(Refer to the enclosed Service and Support Card.)
÷ Remove dust or lint from the disc with a soft cloth by
wiping from the inside to the outside edge rather than in
a circular motion.
÷ Do not use record-cleaning or anti-static agents as the
solutions may cause damage to a disc.
Always store your discs in proper DVD-R storage cases when
not in use. Check for dirt or dust on discs especially on the
recording side before use.
÷ Avoid touching or scratching the signal surface (shiny
side) of the disc.
÷ Hold the disc by the edges or by the center hole and one
edge.
÷ Do not affix paper or other types of labels to the disc.
÷ Discard warped or cracked discs as they may cause
damage to the drive.
÷ Avoid specialty shaped discs such as hearts or polygons.