Philips dcb310 - Manual (Page 10)

TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock!
No sound
– Volume not adjusted.
• Adjust the volume.
Display error / no reaction to any controls
– Electrical malfunction.
• Press the RESET hole on the bottom of the set with a ball-pen.
Intermittent crackling sound during FM reception
– Weak signal.
• Extend and position the FM/DAB pigtail antenna.
The alarm does not function
– Alarm time/ mode not set.
• See SETTING THE ALARM TIME.
– Volume too low for radio.
• Increase the volume.
The indication “No station available” is displayed.
– DAB coverage is currently not available in your area.
• Wait until the coverage resumes.
– DAB signal is weak.
• Re-locate the set, or adjust the position of FM/DAB pigtail antenna.
The indication “Station off air” is displayed.
– The station is currently out of service.
• Wait until the service resumes. Or, perform a scan by pressing AUTO-SCAN in
DAB mode.
Poor reception
– Signal strength is weak.
• Re-locate the set, or adjust the position of the FM/DAB pigtail antenna. For
DAB, you may also perform manual tuning. See Manual tune.
I cannot hear the DAB station I have selected.
–
2; button was not pressed after changing a station by pressing TUNING +/-.
• Press 2; button to confirm the selection.
Note:
In case of malfunciton due to electrostatic discharge, just reset the product
(Reconnection of power source may be required.) to resume normal operation.
DCB310_05_CCR 6/27/08 15:33 Page 10