Philips SPM8713 - Manual (Page 2)

1
3
8
7
5
4
6
2
1
2
3
Fig. 1
Fig. 2
English
Hereby, Philips Consumer Electronics, BLC P&ACC, declares that this SPM8711 is in
compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC.
Français
Par la présente, Philips Consumer Electronics, BLC P&ACC, déclare que l'appareil SPM8711
est conforme aux exigences essentielles et aux autres dispositions pertinentes de la directive
1999/5/CE.
Español
Hereby, Philips Consumer Electronics, BLC P&ACC, declares that this SPM8711 is in
compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC.
S S
Electric-, Magnetic- and Electromagnetic Fields (EMF)
1. Philips Royal Electronics manufactures and sells many products targeted at consumers,
which, like any electronic apparatus, in general have the ability to emit and receive electro
magnetic signals.
2. One of Philips' leading Business Principles is to take all necessary health and safety
measures for our products, to comply with all applicable legal requirements and to stay
well within the EMF standards applicable at the time of producing products.
3. Philips is committed to develop, produce and market products that cause no adverse
health effects.
4. Philips confirms that if its products are handled properly for their intended use, they are
safe to use according to scientific evidence available today.
5. Philips plays an active role in the development of international EMF and safety standards,
enabling Philips to anticipate further developments in standardization for early integration
in its products.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including interference that may cause
undesired operation.
Note!
This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is con-
nected.
• Consult the dealer or an experienced radio/TV technician for help.
Any unauthorized modification to this equipment could result in the revocation of the authori-
zation to operate the equipment.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTER-
FERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE
THE EQUIPMENT.
FCC compliance
Notes
Notes
Notes
Notes