Panasonic KX-NT700 - Manual (Page 33)

Making Conference Calls
While on a call, you can make another call and establish
a conference call (i.e., a 3-party call) including yourself
and 2 other parties. You can establish a conference call
using the following types of calls.
– 2 IP calls (Peer to peer mode only; see page 25)
– 1 IP call and 1 TEL call
– 1 IP call and 1 PS call
– 1 IP call and 1 PC call
To establish a conference call when you receive a call,
see page 34.
Conference calls using the IP and TEL lines
1.
Press
CONF
to put the current call on hold.
2. Confirm that the desired line ("IP" or "TEL") is
selected.
• If the unit is in IP-PBX mode, the available line
is automatically selected. Continue from step
3.
• If the unit is in peer to peer mode and the current
call is an IP call, you can change the selected
line by pressing the left function button ([F1]).
The IP line is selected. The TEL line is selected.
[F1] [F1]
• If you cannot select the desired line, press
BACK
, then change the "Line
Selection" setting (see page 30). After you
have changed the setting, repeat this procedure
from step 1.
3. Call the party you want to add to the conversation.
• You can end the second call and return to the
original call by pressing
BACK
.
• To call a party stored in the phonebook, see
page 32.
4. After the called party answers, press
CONF
to
begin the conference call.
• Before beginning the conference call, press
END
to end the second call and return to the
original call.
Note
• We recommend setting the "TEL Line Level
Reduction" setting to "On" when establishing
conference calls that use the TEL line (see
page 49).
Adding a PS or PC line call to an IP call
1.
Confirm that the "Line Selection" setting is set
to "IP + PS" or "IP + PC" as necessary (see
page 30).
2. Press
CONF
to put the current call on hold.
• If the unit is in IP-PBX mode, the PS or PC line
is automatically selected. Continue from step
4.
3. Peer to peer mode only: Press the left function
button ([F1]) to select the PS or PC line.
Example: Pressing
PS
to select the PS line.
The IP line is selected. The PS line is selected.
[F1]
4. Make a call using the PS or computer.
5. After the called party answers, press
CONF
to
begin the conference call.
• Before beginning the conference call, press
END
to end the second call and return to the
original call.
Ending a Conference Call
Press [ ] to disconnect both parties.
or
1. Press
END
.
• Press
BACK
to continue the call.
2. Press [ ] or [ ] to select the party you would like
to remove from the conference, then press
SELECT
.
• The selected party is disconnected and you can
continue to speak with the remaining party.
• To disconnect both parties, select "All", then
press
SELECT
.
Document Version 2008/10 Operating Instructions 33
Making and Answering Calls