Pella Impervia Sliding Patio Door With Fins 803V0102 - Manual (Page 6)

Caution: Ensure use of low expansion polyurethane window and door installation
foams and strictly follow the foam manufacturer’s recommendations for application.
Use of high expansive foams or improper application of the foam may cause the door
to bow and hinder operation.
A. Apply insulating foam sealant. From the interior, insert
the nozzle of the applicator approximately 1" deep into
the space between the door and the rough opening and
apply a 1" deep bead of foam. This will allow room for
expansion of the foam and will minimize squeeze out.
Apply sealant across interior surface of shims to create
a continuous seal. For windows with jamb extensions
installed, ensure the foam is placed between the
window frame and the rough opening, not between the
jamb extension and the rough opening. Follow foam
manufacturer's instructions.
Note: It may be necessary to squeeze the end of the
tube with pliers to be able to insert into the space
between the window frame and the rough opening.
DO NOT completely fill the space from the back of the
fin to the interior face of the opening.
*OUFSJPS
"
B. Check the door operation by opening and closing the door.
Note: If the door does not operate correctly, check to make sure it is still plumb, level,
square and that the sides are not bowed. If adjustments are required, remove the
foam with a serrated knife. Adjust the shims, and reapply the insulating foam sealant.
Note: If the optional Patio Door High Performance Panel Retainer was ordered with
the sliding door, install the high performance roller retainer before installing the
vent panel. Follow the instructions included with the parts.
"
TWO OR MORE PEOPLE WILL BE REQUIRED TO HANDLE THE PANEL SAFELY.
A. Insert door panel. From the exterior of the building, tilt the
top of the panel toward the door frame and insert the top
of the door panel into the top track. Move the bottom of the
panel toward the door frame until it is vertical. Gently set the
panel down into the bottom track.
Note: Be careful not to pinch your fingers between the
two panels.
B. Install the handles. Follow the instructions included in the
hardware box.
C. Install the bumpers and retainer. Follow the instructions attached to the parts bag.
D. Check door operation. Open and close the door a few times to check for
proper operation.
Note: If there are any problems with the operation of the door, recheck shim locations
and adjust for plumb and square.
E. Install screen. Use the screen instructions included with the screen door.
5A
5
REINSTALL THE VENT PANEL - OX/XO DOORS ONLY
6
INTERIOR SEAL
6A