Panasonic BL-C1A - Manual (Page 73)

Operating Instructions
[For assistance, please call: 1-800-272-7033] 73
6. Set the image buffer frequency and the Motion deactivation time, and click
[Next>].
Note
Due to the network environment, object and the number of simultaneous
accesses, the camera may not record the number of images that you set. In
this case, set the image buffer frequency longer.
• Clicking [
• Clicking [Cancel] takes you back to the Trigger page without saving
changes.
Setting Description
Enable Pre-
trigger Image
Buffer • Check the box to enable the setting. The camera buffers or
transfers the image right before the motion detection signal
is detected.
• Set an interval, number of images to buffer and total
number (see page 132). The number of buffered images
may not match the total number due to memory capacity,
image resolution, image quality or what object you view.
Enable Post-
trigger Image
Buffer • Check the box to enable the setting. The camera buffers or
transfers the image right after the motion detection signal
is detected.
• Set an interval, number of images to buffer and total
number (see page 132). The number of buffered images
may not match the total number due to memory capacity,
image resolution, image quality or what object you view.