Philips 19PFL5404/60 - Manual (Page 34)

32
Note
You must map the audio input from the •
connected device to your TV in order to use
this feature.
Enable remote control pass-through
1
Enable one-touch play and one-touch
standby between easylink compliant
devices by following the instructions
in the previous section (see ‘Enable or
disable EasyLink’ on page 31 ).
2
Press ( Home).
3
Press to select a device with
HDMI connector from your home menu.
4
Press OPTIONS.
5
Press to select [Enable RC pass] and
press OK.
RC pass-through is enabled on the
»
selected device.
Note
Easylink compliant device must be connected •
to the TV via HDMI connector.
HDMI Device
Amplifier
HDMI HDMI
2
Press ( Home).
3
Press to select [Setup] > [Sound]
> [TV speakers] > [Auto EasyLink].
The TV speakers are turned off
»
automatically when content from an
Easylink compliant system is detected.
4
Press to select [Setup] > [Sound]
> [TV speakers] > [On] to disable
system audio control and enable the TV
speakers.
Note
If you select • [TV speakers] > [Off], the TV
speakers are muted.
Connect an ampliÀ er
An amplifi er such as Home theatre System or
AV receiver can be used to play audio from an
Easylink compliant device connected to your
TV.
An amplifi er can be connected in the following
different ways :
An amplifi er with only one HDMI output. •
Audio can be played by the amplifi er
from the device or TV.
Amplifi er with one HDMI input and •
several HDMI outputs. Audio can
be played by the amplifi er via HDMI
connector from your device.
HDMI Device
Amplifier
HDMI
SPDIF OUT /
Analogue Audio HDMI
SPDIF OUT/
Analogue audio
1 2
EN