Pentair Intellitouch ScreenLogic - Manual (Page 111)

101
IntelliTouch ScreenLogic User’s Guide
To install the in-wall Touch Screen device:
1. Ensure that no electrical power is being supplied to the device.
2. Prepare the Ethernet cable and AC power cable ready to route through the opening in the lower rear housing.
3. Remove the lower knockouts from rear metal housing.
4. Mount the rear metal housing into the wall frame opening. Secure the rear metal housing to the wall frame with
the appropriate number of screws. For added stability, use the side brace/bracket (Wing) as an interface
between the rear metal housing and the frame edge, e.g., a wall stud. Do not use the screw openings intended
for securing the display assembly to the rear metal housing.
5. Route the Ethernet cable and AC power cable up through the lower opening in the rear metal housing unit.
6. Mount the display assembly into the rear metal housing. Secure the Display with the provided screws.
7. Place the bezel on top of the display and snap it into place.
8. The installation is complete.
Rear metal
housing
Bezel
Display
Assembly
Side brace/bracket