Philips SJA9192/17 - Manual (Page 5)

a) Caller ID unit 1 pc.
b) Stand studs 2 pcs.
c) AC power adapter 1 pc.
d) Long phone line cord 1 pc
e) Short phone line cord 1 pc
INSTALLING BATTERIES
Please install 4 x AAA batteries (alkaline batteries are recommended)
to retain the Caller ID records and keep real time clock running in case
there is a power failure.
IMPORTANT :
a) Use only fresh batteries of the required size and recommended
type.
b) Do not mix old and new batteries, different types of batteries
(standard, alkaline or rechargeable) or rechargeable batteries of
different capacities.
c) When replacing the batteries, if you do not install the new bat-
teries within 30 seconds
after removing the old ones, you may
lose all information stored in your unit.
d) If you do not plan to use your unit with batteries for a month or
longer, remove the batteries. Batteries can leak chemicals that can
destroy electronic parts.
e) Dispose of old batteries promptly and properly. Do not burn or
bury them.
When the Low Battery icon ( ) appears, replace the batteries.
1. Disconnect the telephone line.
2. Open the battery cover by inserting a sharp object (such as a clip
or a pencil) into the two slots at the top of the battery compart-
ment cover on the bottom of your Caller ID unit.
3. Place the new batteries in the compartment following the polari-
ty symbols (+ and -) marked inside.
4. Replace the battery cover.
5. Reconnect the telephone line.
IMPORTANT :
When replacing the batteries, if you do not install the new batter-
ies within 30 seconds after removing the old ones, you may lose all
Caller ID records stored in your Caller ID unit.
5
Installation
EN