Philips SJA9192/17 - Manual (Page 11)

The LCD display shows “PICK UP OR ADJ” after you press
[DIAL] button.
3. Press [DIAL] button again to change number format among:
a) 7 digits (phone number)
b) 10 digits (area code + phone number)
c) 11 digits (1 + area code + phone number)
4. Lift the Handset to dial the number shown.
IMPORTANT:
a) You must pre-store an area code before you can adjust the numbers
format. Refer to the“Set Area Code” section on page 7.
b) If you have set your local area code, area code of all incoming num-
bers will be compared against your pre-set local area code to deter-
mine if it is a local call.
c) Only the last 7 digits of the incoming number will be shown on the
LCD display if it is a local call. If it is not a local call, 11digits (1 + area
code + phone number) will be shown when dialing back.
DELETING CALLER ID RECORD
When the Caller ID record is full, it automatically deletes the oldest
Caller ID record as a new call comes in.You can also delete individual
call or all calls in the Caller ID record.
To Delete A Caller ID Record
1. While reviewing a Caller ID record, press [DELETE] button and
the LCD display shows “DELETE CALL?”.
2. Press [DELETE] button again to delete.
To Delete All Caller ID Records
1. While reviewing a Caller ID record, press and hold [DELETE] but-
ton for about 3 seconds.“DEL ALL CALLS?” appears on the LCD
display.
2. Press [DELETE] button again to delete all records.
11
Operation
EN