Philips SBCSC465 - Manual (Page 7)

EN
7
Baby unit
The baby unit can be mains or battery operated.When batteries
are installed, you have an automatic back up in case of mains
failure.
Mains operated use
1 Connect the power adapter cord to the power supply jack
(DC 9V — —< <+ + - A-3) of the baby unit.
2 Connect the AC power adapter (A-9) to a wall outlet.
➜ The baby unit is now ready for mains operated use.
Battery operated use
1 Remove the battery compartment cover (A-8) of the baby
unit, using a coin.
2 Insert four 1,5V AA batteries, noting the + and – configuration
inside the battery compartment (batteries are not supplied, we
recommend Philips Alkaline batteries).
3 Close the battery compartment cover (A-8), using a coin.
➜ The baby unit is now ready for battery operated use.
Parent unit
A rechargeable battery pack has already been installed in the
parent unit.
1 Connect the power adapter cord (B-2) to the power supply
jack (DC 9V — —< <+ + - B-14) of the charging base (B-3).
2 Connect the AC power adapter (B-1) to a wall outlet.
3 Place the parent unit in the charging base (B-3).
> The charging light (B-4) lights up red.
4 Leave the parent unit in the charging base (B-3) until the
batteries are fully charged (at least 14 hours).
> When the batteries are fully charged, the charging light (B-4)
will gradually dim.The parent unit can now be taken out of
the charging base and used cordlessly for up to 10 hours.
Getting your baby monitor ready