Peavey LL916 - Manual (Page 4)

INSTALLATION & OPERATION
The Lubell Labs model LL916 underwater speaker is a precision instrument that deserves careful
handling. The following simple rules will serve as a guide to achieving maximum life:
1. CAUTION! Carefully inspect the underwater speaker cable before each use, and do not
use if damaged. Do not attempt to open and self-repair the LL916 as this will void the
warranty. If speaker cable needs replacement, please return the unit to us for low cost
replacement. Please contact your installing dealer for questions regarding service, or
call Lubell customer service at (614) 235-6740 between 8:30-17:00est.
2. CAUTION! Always vacate the water during electrical storms or inclement weather.
3. CAUTION! Be sure that your amplifier is connected to a GFCI protected AC outlet
only, and is installed indoors on a shelf or in a vented equipment rack in an area with
low humidity. If the amplifier will be used portably, it must be kept on a stationary
wooden equipment table indoors with a minimum distance of 10' away from the water.
4. A UL813 listed commercial sound amplifier must be selected that provides a 25V constant
voltage speaker output. Allow 37.5 watts power consumption for each LL916/AC205
connected to the 25V line. We recommend Peavey UMA752 mixer/amp or IPA752 power
amp (75 watts) to power one or two LL916/AC205’s; Peavey UMA1502 mixer/amp or
IPA1502 power amp (150 watts) for three or four LL916/AC205’s; Peavey IPA300T for five
to eight LL916/AC205’s.
5. Connect AC205B/C transformer box(es) in parallel and in phase to the “25V” speaker output
terminals on amp. AC205B box(es) must be located indoors, and may be located by the
amplifier, or located closer to the OP1 jack plate(s) providing lower loss for long cable runs.
Do not use L-pad or autoformer between the underwater speaker(s) and the amplifier. If
remote volume control is needed, use the “remote volume” pot connection on the Peavey
UMA series mixer, or insert a Crestron type volume controller between the source device
(receiver, pre-amp, CD/tape) and the Peavey UMA amplifier’s stereo tape/aux input.
6. The OP1 connector plate fastens to a single-gang all-weather J-box, which should be
mounted at least 8” above the deck to a cabana wall or wooden post by the pool. For single
speaker installations, center the J-box on the length of the pool where the U/W speaker will
be placed; Run 1/2” conduit from this box back to the house. For two speaker installations,
mount each J-box on a post ¼ pool length from each end of the pool and run 1/2” conduit
between J-boxes, and 1/2” conduit from one box back to house. Install 14 gauge 2 conductor
speaker wire in the conduit between each transformer box and OP1 jack plate. Connect one
end (of each pair) to “LL916” terminals (B=black, W=white) on AC205B transformer box
and other end to OP1 connector plate’s black and white wires. Connect the green ground
wire from each OP1 connector to a good ground using #8 copper.
7. Take good care of the U/W speaker cable, as it is not covered under the guarantee. Do not
use the speaker cable to lift, lower, or support the underwater speaker. Instead attach a sturdy
1/4" nylon cord to the speaker cage for this purpose. Lower the speaker to a 6’ (1.83 meter)