Figure 7 – ParaBody 360101 User Manual
Page 6
6
STEP 7
Install the NEW PRIMARY CABLE (13) using the following steps:
• Route the CABLE (13) back over one pulley in the GUIDE ROD SUPPORT, down through the PULLEY BRACKET (2) and over the
second pulley in the GUIDE ROD SUPPORT.
• Route the CABLE (13) around the FLOATING PULLEY BRACKET as shown in FIGURE 7.
• Route the CABLE (13) through the TOP BOOM as shown in FIGURE 7. The pulleys in TOP BOOM may need to be temporarily removed
to perform this step. (Note: Make sure the CABLE is running in all the pulley grooves.)
FIGURE 7
2
13
• Screw the threaded end of CABLE (13) into the HEAD PLATE ASSEMBLY.
IMPORTANT: Cable must run
in all the pulley grooves.
0
1
2
3
4
5
6
1/2
1/2
1/2
1/2
1/2
1/2
See also other documents in the category ParaBody Sports and recreation:
- Free Weight Systems (5 pages)
- 886101 (3 pages)
- 425/660 (2 pages)
- 822 (9 pages)
- 848101 (14 pages)
- 881 (26 pages)
- Free Weight Smith System (5 pages)
- Leg Press 100101 (14 pages)
- 777 (5 pages)
- 832102 (14 pages)
- Leg Press 100 (11 pages)
- 205101 (1 page)
- 425 (2 pages)
- 440 (33 pages)
- 426103 (45 pages)
- Hip Sled System (24 pages)
- 824 (8 pages)
- 425103 (40 pages)
- GS2 (24 pages)
- 826 (8 pages)
- 856 (6 pages)
- 400101 (27 pages)
- 829 (14 pages)
- 435104 (13 pages)
- GS6 (8 pages)
- 842 (6 pages)
- 778 (13 pages)
- 375101 (22 pages)
- Leg Press 5 (15 pages)
- 838 (10 pages)
- 441101 440 (10 pages)
- LP5 (15 pages)
- Home Guide (9 pages)
- 888 (15 pages)
- cm3 (8 pages)
- 870 (4 pages)
- 893103 (20 pages)
- 890 (10 pages)
- 250101 (18 pages)
- 843 (12 pages)
- GS4 (1 page)
- 849 (7 pages)
- 855 AB (9 pages)
- 883 (31 pages)