Figure 14 – ParaBody 360101 User Manual

Page 11

FIGURE 14

STEP 14

• The 832 LEG PRESS is equipped with a spring pin adjustment to accommodate different sized users and allow easy entry and exit from

the machine. To use, you must slightly push against the foot plates to take tension off the pin.

• To set the correct amount of tension in the cables, adjust the 832 LEG PRESS into the last adjustment hole (so the LEG PRESS is spread

apart) and remove the WEIGHT STACK PIN. Thread the PRIMARY CABLE (13) into the HEAD PLATE ASSEMBLY until both
PULLEY BRACKETS (2) are held against the TOP BOOM and the cable is slightly pulling up on the HEAD PLATE. Tighten the jam
but securely. Next, thread the LEG PRESS CABLE (14) into the PULLEY BRACKET (2) until cable is tight , then tighten the jam nut
securely.

SPRING PIN ADJUSTMENT

Thank you for purchasing the Parabody 360101 Leg Press Adapter Kit. If unsure of proper use of equipment,
call your local Parabody distributor or call the Parabody customer service department at (800) 328-9714.

ADJUST!

• If further adjustment is needed, lossen and adjust the pulley attached to the slotted tab on the BENCH FRAME. (NOTE: It is natural

for the LEG PRESS CABLE to slacken when seat is adjusted inward.)